[Haskell] Haskell on QNX?

[Liwen Huang]

I have successfully installed Hugs on QNX machine. As far as I can remember, 
you only need to make a few changes in the Makefile, (change gcc to qcc and 
change to proper qcc flags).

Liwen
----- Original Message ----- 
From: <mmm92 at pantheon.yale.edu>
To: "Malcolm Wallace" <Malcolm.Wallace at cs.york.ac.uk>
Cc: <haskell at haskell.org>
Sent: Thursday, March 24, 2005 12:50 PM
Subject: Re: [Haskell] Haskell on QNX?


> Malcom,
>
>> ... Thus it should be
>> possible to get either Hugs or nhc98 up and running very quickly,
>> maybe even straight out of the box, on all architectures.
>
>  So it sounds like nobody has done this yet (or at least nobody on this
> list)?  I'm very unfamiliar with QNX ATM, but perhaps when I'm
> acclimated, I  might try to get Hugs running on it.  Thanks.
>
>  - Matt
>
> Quoting Malcolm Wallace <Malcolm.Wallace at cs.york.ac.uk>:
>
>> "Matthew M. Munz" <mmm92 at pantheon.yale.edu> writes:
>>
>> >    Is it possible to compile and run Haskell programs on QNX? [1]
>> > [1] http://www.qnx.com/
>>
>> >From a brief glance at the QNX website, it appears to support POSIX,
>> GNU
>> make tools, and gcc-compatible C compilers.  Thus it should be
>> possible
>> to get either Hugs or nhc98 up and running very quickly, maybe even
>> straight
>> out of the box, on all architectures.
>>
>> It is also likely that ghc could be persuaded to bootstrap (with a
>> little
>> work) on at least PowerPC and ix86 platforms, since the native
>> codegen for
>> those architectures is well maintained - MIPS, SH-4, StrongARM, and
>> Xscale
>> would be much more of a challenge for ghc though!
>>
>> Regards,
>>     Malcolm
>> _______________________________________________
>> Haskell mailing list
>> Haskell at haskell.org
>> http://www.haskell.org/mailman/listinfo/haskell
>>
>
>
> _______________________________________________
> Haskell mailing list
> Haskell at haskell.org
> http://www.haskell.org/mailman/listinfo/haskell