how to compile non-dynamic ghc-7.8.2 ?
jwlato at gmail.com
Sun Apr 27 23:00:46 UTC 2014
cabal-install-18.104.22.168, using Cabal 22.214.171.124. But this also happened IIRC
with just ghc, no libraries installed, and no cabal anywhere on the path.
In any case, thus far the worst behavior I've seen from a too-old cabal is
a compile failure, not a core dump :)
On Fri, Apr 25, 2014 at 9:47 AM, Carter Schonwald <
carter.schonwald at gmail.com> wrote:
> @john, what version of cabal-install were you using? (i realize you're
> probably using the right one, but worth asking :) )
> On Fri, Apr 25, 2014 at 12:25 PM, John Lato <jwlato at gmail.com> wrote:
>> On Apr 25, 2014 5:36 AM, "Bertram Felgenhauer" <
>> bertram.felgenhauer at googlemail.com> wrote:
>> > John Lato wrote:
>> > > I'd like to compile ghc-7.8.2 with DynamicGhcPrograms disabled (on
>> > > linux). I downloaded the source tarball, added
>> > >
>> > > DYNAMIC_GHC_PROGRAMS = NO
>> > I've had success with setting both
>> > DYNAMIC_BY_DEFAULT = NO
>> > DYNAMIC_GHC_PROGRAMS = NO
>> > and removing the 'dyn' way altogether from GhcLibWays by setting
>> > GhcLibWays = v explicitely. I expect that the latter is optional;
>> > my goal was only to speed up the build.
>> > (The lines were copied from the perf-cross settings.)
>> I tried disabling dynamicByDefault also, but that didn't help. It may be
>> a problem with lib ways though, I'll try that.
>> Thanks, John
>> > Cheers,
>> > Bertram
>> > _______________________________________________
>> > Glasgow-haskell-users mailing list
>> > Glasgow-haskell-users at haskell.org
>> > http://www.haskell.org/mailman/listinfo/glasgow-haskell-users
>> Glasgow-haskell-users mailing list
>> Glasgow-haskell-users at haskell.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Glasgow-haskell-users