Unregistered build (was Re: AMD64)

[Simon Marlow]

On 16 June 2004 13:50, Bennett Todd wrote:

> 2004-06-16T10:33:49 Simon Marlow:
>> On 15 June 2004 16:24, Bennett Todd wrote:
>>> 2004-06-15T14:52:53 Simon Marlow:
>>>> After hc-build, you should unpack a completely fresh GHC source
>>>> tree, somewhere else.  Then 'cd' into this tree, and issue the
>>>> configure/make commands.
>>> 
>>> Alas, no joy; again, "make" does nothing.
>>> 
>>> These Makefiles are cleverer than I am, I can't quite figure out why
>>> make is just silently exiting with status zero.
>> 
>> This is very strange.  Perhaps try 'make -d'?
> 
> Please find the result attached, thanks!
> 
> -Bennett

Hmmm.  Try these please:

  make show VALUE=ProjectsToBuild
  make show VALUE=ProjectsThatExist
  make show VALUE=SUBDIRS

Cheers,
	Simon